London Flat Roofing. 154c Fleet Road, Hampstead, London NW3 2QX
Replacement of an old flat asphalt roof using insulation covered with EPDM, a skylight and a new insulated tank box. We had to have a tin roof over the roof for this project, because we knew the roof would be open for longer than a day. The new flat roof will be insulted to the new building regulations. New flat roofs today have to be insulated to a very high standard today.
Steven has been working on London's flat roofs for over 30 years. He has come across just about every type of flat roof in existence. From asphalt to zinc. If you have any questions or need any advice, feel free to drop a comment below and he will endeavour to reply.
The builder has built a new side extension and we left the decking open ready to lay a new [...]
This gives an idea as to what we were up against. Our specification for this new flat roof was [...]
This is a skylight in an old three layer felt roof. Although the roof is leaking and needs changing, [...]
The roof has been stripped and the insulation has already been taken up the scaffolding, ready to go down. [...]
Liquid rubber being laid over ply and felt. If you have watched video 1, you would have seen the [...]
Ply decking with torch on felt being applied over the top, ready for liquid rubber coating. When dry, I [...]
What is EPDM Rubber? Good question – I’m asked this all the time! EPDM is a manmade rubber that [...]
The Kemper system is laid wet into a fleece, as you can see we’ve even covered the internal surfaces [...]
London Flat Roofing investigated a leak caused by two old joined leaking roofs of different materials – plastic and [...]
One thing’s for sure, all the insulation on the roof will have to come out and we will have [...]
Comments (1)
Hi Steve, we’re selling our house and the buyers survey says that the epdm flat roof over kitchen extension needs renewing. We’re trying to clarify what’s wrong with it.
My father in law advises that the following insulation was used at the time the extension was built in the 80s –
4inches. Marine ply top and bottom in between was fire retardent foam as approved by the council surveyor. All purlings were coated with approved preservative. Would this meet current building rev requirements or also need upgrading?
The roof is approx 18-19 sq metres. We live in London E13.
I’m trying to ascertain approx how much the renewal job would cost, including upgrading insulation if needed. I’d be v grateful if you could advise. We need to discuss further with the buyer in the next couple of days. Thank you very much.
Would the cost include sign off for building regs purposes too?