Parapet Wall Chimney Pots Being Dressed With EPDM Single Ply Rubber

Parapet Wall Chimney Pots Being Dressed With EPDM Single Ply Rubber

EPDM Rubber Dressed Around Chimney Pots

This gives an idea as to what we were up against. Our specification for this new flat roof was to strip the old roof, apply insulation and re-roof using EPDM rubber. Just what we were going to do with the parapet walls and chimneys was always going to be up for debate and, as part of the pricing, we had discussed that a Provisional Costs (PC) sum should be put to one side to deal with the renovation of this area.

EPDM Rubber Dressed Around Chimney Pots

As the insulation went down and the EPDM roof covering was laid, it was worked out that we could easily lap up the parapet wall and dress around the chimney pots.

EPDM Rubber Dressed Around Chimney Pots

So, as you can see the upstands to the parapet wall were made, and the EPDM single ply was cut in around each pot.

EPDM Rubber Dressed Around Chimney Pots

Time was taken to dress the EPDM rubber around the posts, making the actual sealing to each pot neater as an end result.

EPDM Rubber Dressed Around Chimney Pots

As you can see here, a superb end result. It was a nice watertight job, neat, tidy and a good solution to a difficult problem.

EPDM Rubber Dressed Around Chimney Pots

Another photo of the finished job.

social position

Share this post

Leave a Reply

Your email address will not be published. Required fields are marked *